It is quite an amazing thing when you find a car wash that is just right for you. You can give it a quick washing and get on with your day. Or, you can spend a good chunk of the day waiting for your car to be cleaned and dried. It’s up to you.
If you are looking for a simple solution then you need to check out the Speedway Car Wash. With only six simple steps, you can have your vehicle cleaned and ready to go in no time. All you need is a hose and some windshield wiper fluid. You can get the latter at any hardware store.
Get It Wet
The first step is to get your car as wet as possible. This is quite an easy task as there is usually no rain or snow around when you need to wash your vehicle. You can use any source you want, be it a hose, a garden hose, or even a beer bottle. Just make sure that you wet all the surfaces that will be touched by the car wash. This means the exterior mirrors, the hood, and the floor. You should also use a bucket or container underneath to collect the excess water so that it does not remain on the surface where it can damage some nearby building or object.
Dry It
Now that you have your car thoroughly wet, it’s time to let it dry. You have three options here: you can either let it air dry, you can use a hair dryer, or you can use a towel and some elbow grease. Personally, I recommend the last option as it saves you both time and energy. Simply use a towel to blot any excess water from the exterior surfaces of your car and then give it a quick wipe down. Do not be afraid to go over every inch of your car’s exterior with a dry towel as this will make the difference between a clean and a dirty car. If you do not have time for a full wash and dry cycle then at least do an interior wipe down or an exterior dry-off. This will prevent any unnecessary interior damage that may occur due to excessive water accumulation during the day. You can also use a dryer on a few exterior items like the hood and the roof because this will save you time in the long run. Do not overload the motor or set the temperature too high as this may cause damage.
Add Detergent
Detergents are important to remove dirt and grime from your vehicle’s surface. Without them, your car or truck may look like it has just come out of the factory. While there are many types of detergents, most car washes come with a simple solution called “dishwashing liquid.” You will find many different brands of dishwashing liquids at any market but the general consensus is that they are quite effective. For best results, use a mild detergent and clean water. Never use heat or agitation when washing your vehicle. This will only lead to severe wear on the engine and premature breakdowns. Agitation also makes the soap adhere better to the surface thus increasing the effectiveness of the wash.
Wash
It’s time to wash your car now. Remember, choose a gentle cycle for this part, especially if it is your first time using a liquid detergent. Start from the top and work your way down using the hose. For maximum cleanliness, use the full flow of water from the faucet and do not cut off the stream when rinsing. Never fill the sink above the height of your car. This will make it impossible to reach all the surfaces.
After you have washed all the exterior surfaces, it’s time to move to the interior. Start by wiping down the dashboard and any other interior surfaces that you can reach with your arm while sitting in the driver’s seat. After that, concentrate on the floorboards and the steering wheel. Do not forget about the windows and the mirrors as these are all important to cleanse as well. When you are finished, leave the windows open so that the inside air can dry out a little. This will help preserve the freshness of the air inside your car or truck for a good while.
Dry
Drying your vehicle is quite an important step. Even if you followed the previous step thoroughly then it is still imperative that you thoroughly dry all the surfaces before moving on to the next step. You can use any source of heat you want here but the most effective option is the sun. If you do not have time for a full dry cycle then at least do an air dry on your hood and roof. This will help remove most of the water from your car’s exterior. Do not leave any area of your car’s surface wet as this will only invite dirt and grime back later on when the weather is dry. This is quite frustrating and may ultimately damage your vehicle.
Final Steps
Once you have done all that, it’s time to take care of the little details. These are quite simple steps but they will make all the difference. First, turn off the water source and disconnect the hose. Now, it’s time to secure all the windows and lock the doors. You should also check your tires for wear and tear as this will also make a difference in how your car or truck handles on the roads. You may want to consider replacing them as soon as possible. The air in your car or truck will no longer be fresh and it will cause you to smell like a wet dog. This is quite an unpleasant sensation and it will not do much to improve your day. On that note, I would like to conclude this article on how to use a Speedway Car Wash. This was quite a lengthy process but the results are quite gratifying. Your car or truck will look like it came out of the showroom and, more importantly, it will feel like it too. This, in turn, will make you feel more secure on the road as you will no longer fear for its safety in bad weather conditions. So, what are you waiting for? Get out there and wash that car!